40
EN
3. Press the steam button and the device will start preheating. The "single
cup" and "double cup" indicator lights will turn o and the "steam/preheat"
indicator light will ash. Wait until the indicator light stops ashing, then
preheating is complete.
4. Place an empty cup under the steam wand, turn the steam knob anti-
clockwise to the stop, drain some water into the steam wand, and after steam
has escaped, turn the steam knob clockwise back o.
Note: Do not turn the steam knob too fast, as the steam can build up in a short
time, increasing the risk of explosion.
5. Place the stainless steel milk cup under the steam nozzle and dip the steam
pipe nozzle about 2 cm below the surface of the milk.
6. Turn the steam control fully anti-clockwise to froth the milk. The "steam/
preheat" indicator light will ash.
7. When you have prepared the desired amount of milk froth, turn the steam
knob clockwise to stop the steam emission. Remove the milk cup and pour
the frothed milk into the prepared espresso. The cappuccino is now ready.
Depending on your taste, you can rene it with sugar or cocoa powder.
Note: As soon as no more steam is coming out of the steam pipe, immediately
clean it of milk residues with a damp sponge to prevent the milk froth from
sticking to the wall of the steam pipe. During operation, the surface of the
steam wand becomes very hot. Be careful not to scald yourself.
8. Press the on/o button to turn o the device.
Note: Allow the espresso machine to cool down for at least 5 minutes before
brewing coee again. Otherwise, your espresso may have a burnt smell.
Hot water preparation
• With this function you can preheat your coee cup to ensure that the
temperature of the coee does not drop. This improves the taste of the coee.
• Cleaning the coee cup: After drinking coee, you can also use this function
to make hot water to clean the cup. This makes cleaning the cup easier and
more convenient.
To prepare hot water:
1. Place a cup under the hot water outlet.
2. When the "single cup", "double cup" and "steam/preheat" indicator lights are
solid, turn the steam dial anti-clockwise (you do not need to press the "steam/
preheat" button). Hot water will run out of the hot water pipe immediately.
The "single cup" indicator light ashes while hot water is being prepared.