Klarstein Cookio - Page 29

29
EN
What? How? Important!
Boilovers, melts,
and hot sugary
spills on the
glass
Remove these immediately
with a sh slice, palette knife
or razor blade scraper suitable
for ceramic glass cooktops, but
beware of hot cooking zone
surfaces:
1. Switch the power to the
cooktop off at the wall.
2. Hold the blade or utensil at
a 30° angle and scrape the
soiling or spill to a cool area
of the cooktop.
3. Clean the soiling or spill up
with a dish cloth or paper
towel.
4. Follow steps 2 to 4 for
“Everyday soiling on glass”
above.
• Remove stains left by
melts and sugary food
or spillovers as soon as
possible. If left to cool on
the glass, they may be
difcult to remove or even
permanently damage the
glass surface.
• Cut hazard: when the
safety cover is retracted,
the blade in a scraper
is razor-sharp. Use with
extreme care and always
store safely and out of
reach of children.
Error codes
Problem Possible cause and solution
approach
E0 Unsuitable cooking utensils or the
cooking utensils are not positioned
centrally on the cooking zone.
Use suitable cookware and place it in
the middle of the cooking zone.
E1 Error in the internal circuit. Contact customer service.
E2 Overheating. Make sure that the ventilation opening
is not blocked.
E3/
E4
Voltage is too high / too low. Use a power outlet that matches the
specied voltage.
E5 Error or short circuit of the
temperature sensor or other parts.
Contact customer service.
E6 The hotplate is overheated. Allow the plate to cool down briey
before using it again.