12
EN
COMMISSIONING AND OPERATION
• Make sure all controls are in the „Off“ position („MIN“ pointing up). Plug the
power plug of the unit into the wall outlet.
• The invisible protective layer on the unit must be removed before use. To do this, set
the maximum level and leave the unit switched on for about 4 minutes. Ensure that
the room is well ventilated as this will produce smoke. Switch the unit off and allow
it to cool down completely. The unit is ready for use.
• Only use pans and pots with a at surface that allows good contact with the
hotplate. Ideally, the size of the bottom of the pot should match the size of the
hotplate.
• Adjust the temperature. The hotplates have different levels. Use the lower steps
(MIN 4) for cooking and gentle heating and use the upper steps (5 MAX) for
cooking.
• When the appliance is switched off, residual heat remains. This can be used to keep
food warm for a short time.
• After use, turn the switch to „MIN“ and unplug the appliance.
CLEANING AND CARE
• Before cleaning, unplug the appliance from the wall outlet and allow it to cool
down.
• Rub the hot plates with a damp cloth.
• Do not use scouring pads or steel wool as this may damage the surface of the
appliance.
To Next Page
Loading...
