12
EN
USE AND OPERATION
Heat Water
1 Before lling with water, remove the kettle from the base (4).
2 Open the lid and ll the kettle with water up to the desired level (between 0.5 and
1.0 L).
3 After plugging the base to the power outlet, the display turns on for a moment,
all buttons are lit and the appliance beeps twice which means that the base is
connected to the power source and the kettle is placed on the base.
4 Close the lid and place the kettle on the power base (4), the appliance beeps
once, the display turns on and the ON/OFF button stars to ash blue. Below the
horizontal line on the display you will see the current water temperature which will
be visible for about 5 seconds.
• If you do not perform any actions, the kettle turns off automatically.
• Press the ON/OFF button (10) without setting other functions. The kettle turns
on and beeps, the ON/OFF button will be lit red. The kettle boils water up to
100°C, then switches off automatically and beeps three times.
• If you just want to heat up the water, use the boiling temperature buttons [+] or
[-]. Press once to change the temperature. The temperature setting will be shown
on the display. You may select between the predened temperature settings:
from 40°C up to 100°C each 1°C. After reaching the desired temperature of
water, the kettle switches off and beeps three times.
Keep Warm Function
If you want to select the keep-warm function, press the Keep warm function button (7),
the keep-warm symbol will be shown on the display. In this mode press the button [+] or
[-] to set the desired temperature.The temperature adjustment (increase and decrease)
step is 1°C. The available range of temperature setting 40–95°C. In order to switch off
the keep-warm function, press the keep-warm button (7) again or ON/OFF button (10)
to switch off the kettle. Otherwise the water temperature will be maintained at a per-set
level. If no action is taken for 30 minutes in the keep-warm mode, the kettle will switch
off. Press the ON/OFF button (10) again to turn on the kettle (the kettle beeps once).
Important Notes on Use
• The kettle may be used only with the base attached.
• Do not open the lid when boiling water.
To Next Page
Loading...
