Klarstein Valkyrie - Page 20

20
EN
Lighting the side burner
1 Open the lid of the side burner.
2 Push down the side burner control knob and
keep pressing whilst turning anti-clockwise to the
HIGH position (a clicking sound is heard). This
will light the side burner. Observe if the burner
has lit. If not repeat this process.
3 If the burner has not lit after retrying, wait
5minutes and repeat step 2.
4 Adjust the heat by turning the knob to the
HIGH/LOW position.
5 If the burner does not ignite, light the appliance with a match using a long match or
taper. Consult your gas dealer to rectify the ignition.
6 To turn the side burner off, turn the control knob clockwise to the OFF position. If
you wish to turn the complete barbecue OFF, turn the cylinder valve or regulator
switch to the OFF position and then turn the control knob on the appliance
clockwise to the OFF position.
Note: If the burner fails to ignite, turn the control knob off (clockwise) and also turn
the cylinder valve off. Wait ve minutes before attempting to relight with ignition
sequence.
After each use
• “Burning off” the barbecue after every use (for approximately 15 minutes) will keep
excessive food residue to a minimum.
• Clean the barbecue after each use. Do not use abrasive or ammable cleaners, as
it will damage the parts of the product and may start a re. Clean in warm soapy
water. Only clean once the product has cooled down.
HI
OFF
LOW