33
EN
Burner will not light
using ignitor
(Gas issues)
Trying to light wrong
burner
See instructions on control
panel and section in the
Use and Care.
Burner not engaged with
control valve
Make sure valve are
positioned inside of burner
tubes.
Obstruction in burner Ensure burner tubes are
not obstructed with spider
webs or other matted, see
cleaning section of use
and care
No gas ow Make sure LP tank is not
empty. If LP tank is not
empty, refer to “sudden
drop in gas ow.
Vapor lock at coupling nut
to LPtank
Turn off knobs and
disconnect coupling nut
from LP tank. Reconnect
and retry.
Coupling nut ad LP tank
valve not fully connected.
Turn the coupling nut
approximately one-half to
three-quarters
To Next Page
Loading...
