34
EN
Burner will not light
using ignitor
(Electrical issues)
Electrode cracked or
broken;” sparks at crack.”
Replace electrode.
Electrode tip not in proper
position
Tip of electrode should be
pointing toward port hole
in burner. The distance
should be 1/8” to 3/16”.
Adjust if necessary.
Wire and/or electrode
covered with cooking
residue.
Clean wire and or
electrode with rubbing
alcohol and clean swab.
Wires are loose or
disconnected
Reconnect wires or
replace electrode/wire
assembly.
Wires are shorting
(sparking) between igitor
and electrode.
Replace ignitor wire
Push button sticks at
bottom sparking between
ignitor and electrode
Replace igniton.
Wire insulation might be
broken
Inspect wire insulation
and proper connection.
Replace wires if insulation
is broken.
Burner will not
mach light
See ”gas issues;” on
previous page.
Improper method of
match-lighting
See “Pilot Gas Control
Ignition” section of use
and care.
Sudden drop in gas
ow or low ame
Grease buildup. Clean burners and inside
of grill/ rebox
Excessive fat in meat. Trim fat from meat before
grilling.
Excessive cooking
temperature
Turn down the cooking
temperature
Flames blow out
High or gusting winds Turn front of grill to face
wind or increase ame
height.
Low on LP gas. Rell LP tank.
Excess ow valve tripped. Refer to “sudden drop in
gas ow” above
To Next Page
Loading...
