Klein NCVT-6 - Operating Instructions and Maintenance; Checking for AC Voltage; Silent Mode and Auto-Power Off; Maintenance Procedures

To Previous Page

OPERATING INSTRUCTIONS

CHECKING FOR THE PRESENCE OF AC VOLTAGE

cuit to verify tester

ce. If voltage is

1. Prior to use, test on a known live cir

functionality.

2. Place NCV Antenna

near an AC voltage sour

present, the unit will emit audible beeps and the NCV Indicator

will illuminate.

for

will be displayed. All visual

will powersdown

, the

-6 will automatically

SILENT MODE

With the NCVT-6 powered off, press and hold the On/Off Button

five seconds (the NCV On/Off

for NCV mode, or the LDM Control

Button

for LDM mode) to power-on in Silent mode. While Silent

mode is active, the silent mode icon

indicators and display readings will continue to function as normal,

but no audible indicators will be given. Silent mode will remain active

until the NCVT-6 is powered-off.

AUTO-POWER OFF (APO)

While the NCV function is active, the display

following 15 seconds of no voltage detection (the NCV indicator

will remain illuminated). After 4 minutes of further inactivity

NCVT-6 will automatically power-off.

While the LDM function is active, the NCVT

power-off following 15 seconds of inactivity.

y lint-free

CLEANING

Be sure tester is turned off and wipe with a clean, dr

cloth.

Do not use abrasive cleaners or solvents.

. After

exceeding the limits

STORAGE

Remove the batteries when not in use for a prolonged period

of time. Do not expose to high temperatures or humidity

a period of storage in extreme conditions

mentioned in the General Specifications section, allow the tester to

return to normal operating conditions before using.

/ RECYCLE

DISPOSAL

Do not place equipment and its accessories in the trash.

Items must be properly disposed of in accordance with local

regulations.

MAINTENANCE

BATTERY REPLACEMENT

When the Battery Status Indicator

shows only one bar remaining,

the LDM functionality will be disabled, and the NCV functionality has less

than 8 hours remaining. At this point, the batteries should be replaced:

1. Unscrew Battery Cap

and remove/recycle spent batteries

2. .

Install two new AAA batteries

. Note proper polarity

Screw battery cap until fully seated to ensure a tight seal, being careful

not to damage the O-ring

NOTE: Damage to the O-ring can affect

the IP40 dust resistant rating, but will not affect functionality.