Kleinn Sniper - Programming Remote Fobs; Safety Inhibit Feature

Proper Air Valve Wiring (continued)
Constant Power with Ground Switching
In this configuration, one wire from the solenoid is connected to
constant power and the other wire is connected through a pushbutton
switch that supplies ground when pressed. Connect the Pink output
wire from the through a relay (not included) as shown below.
Ÿ Turn off ignition - programming is complete.
TM
Sniper
Programming - Remote Fobs
If you wish to add fobs or replace lost/broken fobs they must be
TM
programmed into the Sniper .
Ÿ With the ignition turned on, press and hold the programming button
for 3 seconds; the LED will turn solid.
Ÿ Press the button on the new remote, then press the button on all
other remotes you wish to keep programmed (up to 4).
Programming - Safety Inhibit
TM
The Sniper has a built in ‘safety inhibit’ that prevents the system from
activating when the vehicle is running. This feature can be turned
on/off by turning the ignition to the 'ON/RUN' position, then pressing the
programming button 5 times. When the LED flashes 3 times, the
Safety Inhibit is turned off. Perform the same process to turn the Safety
Inhibit on. When the LED flashes 5 times, the Safety Inhibit is
enabled.
Pink wire from Sniper
87
85
86
30
87a
+
-
Battery