What Are You Cutting?
Our cutters are designed for multiple industries, multiple uses.
Visit
www.kleverinnovations.net for videos of proper use and additional information.
CAUTION: Even though these are Safety products, please understand that blade edges are sharp.
Proudly made in the U.S.A.
(800) 218-3068
REDUCE CUT INJURIES • REDUCE DAMAGED GOODS • ALWAYS SAFETY READY
Straps / Banding
• Align cutter opening with edge of strap or band.
• Cut banding at a downward 45° angle.
Plastic / Film / Wrap
• Align cutter opening with edge of material.
• Pull cutter in a straight line with even force to
cut through material.
Tip: Klever safety cutters are not designed to
cut metal banding.
Tip: Start the cut from the bottom of the material and pull up
toward the top of the pallet. Keep material taut while cutting.
Mailing / Box Label
• Align cutter tip with outer edge of label.
• Press tip just beneath top layer of box.
• Angle cutter about 45° to box.
• Pull to cut around label.
• Lift up on corner of cut and peel off.
Tip: Repeating for all sides of label allows
for clean removal.
Packing Slip Envelope
• Align cutter tip with top of envelope.
• Apply downward pressure and pull the blade
through the stop sheet of plastic.
Tip: Be careful not to press too deep. Avoid
contacting contents of envelope.
To Previous Page
Loading...