KLIM HTD User Manual

KLIM HTD Gauntlet Glove Instruction Guide
This guide is distributed to client of KAIWERKS, LLC to satisfy regulatory requirement by stating
the required information in the product’s user manuals.
Subject: AHS (Active Heating System) module and variants
Alteration: This document has been modified for KLIM in their custom system in September
2019
How to use
1. Make sure your KLIM HTD Glove is fully charged. (24hrs is recommend for the 1
st
charge)
2. To turn on, press and hold the button for 3 seconds until the light indicator lights up Red
3. Short press to change between heating levels
a. HIGH Heat – indicated by the color RED
Please note that HIGH Heat is only available for 10 minutes at a time. After 10 minutes
your glove will automatically switch to MEDIUM Heat to preserve the temperature inside
the glove. HIGH Heat can be activated again by pressing the button until the indicator
light turns Red.
b. MEDIUM Heat – indicated by the color BLUE
c. LOW Heat – indicated by the color GREEN
4. To turn off, press and hold the button for 3 seconds until the light indicator disappears
Charging
· Only charge the batteries that had experienced similar usage in pairs. Otherwise
assume 12hrs of charge time to balance the paired batteries
· Remove the battery from the zipper pocket located on the inside of the glove
· Let batteries warm up to ambient temperature before charging
· Connect the charger to a wall socket and 2 green lights will come on. (Avoid using a
power strip with other appliances)
· Check that the battery is dry and free of any condensation
· Securely connect the charger terminals to the batteries
o Red light indicates the battery is charging
o Flashing green and red lights indicates 90% charge completed
o Green light indicates charging completed
**If the first red light change to green after connecting the second battery this
means the two pairs of batteries are out of balance and the charge will charge
the weaker battery first to ensure the pair is balanced
· Always charge the batteries after use to prolong battery life
· Always remove the batteries from the charger after charging is complete
· Never charge the batteries below 0⁰C (32ºF) or above 40⁰C (104ºF)

KLIM HTD Specifications

General

Brand	KLIM
Model	HTD
Category	Protection Device
Language	English

Summary

How to Use KLIM HTD Gauntlet Gloves

Glove Initial Charging

Ensure the KLIM HTD Glove is fully charged before first use, with 24 hours recommended for the initial charge.

Powering On and Off

Press and hold the button for 3 seconds to turn the glove on (red light) or off (light disappears).

Adjusting Heating Levels

Short press the button to cycle through HIGH (Red), MEDIUM (Blue), and LOW (Green) heat settings, noting HIGH heat limitations.

Battery Charging Procedures

Charging Preparation and Indicators

Charge batteries in pairs, warm them to ambient temperature, and connect securely. Understand indicator lights: Red (charging), Flashing Green/Red (90%), Green (complete).

Charging Best Practices

Charge batteries after use, remove them once complete, and use only the supplied charger. Avoid charging unattended or in extreme temperatures.

Storage and Safety Precautions

Battery Storage Guidelines

Store batteries at room temperature (0-25°C), away from direct sunlight. Avoid temperatures over 60°C for extended periods.

General Safety Warnings

Consult a doctor if you have temperature sensitivity. Check for skin reddening, use under adult supervision, and do not attempt to open or throw batteries.

Electrical Safety and Disclaimers

Electrical Usage Warnings

Do not use in water or during electrical storms. Lithium batteries are volatile; improper use can cause fire or injury.

Product Compliance and Disposal

Adheres to CE and RoHS/WEEE directives. Dispose of product and accessories separately from municipal waste.

Warranty Information

Product Warranty Coverage

KLIM warrants the product against defects in materials and workmanship for two years from the original purchase date.

Obtaining Service

Contact the reseller or service agent for repairs or replacements. Warranty terms are subject to change without notice.