OPERATING INSTRUCTIONS
IMPORTANT
If the desktop encounters any obstacle in its path during operation, the
screen displays the error message “E-2". Please check that there are no
obstructions above or below the desk, and that the edges are not
touching any wall or other objects.
In order not to strain the motor, it requires a 20-minute break after 2
minutes of operation. If the DUT error message appears, please wait 20
minutes and try again.
If the error E-3 appears on the screen, it means that the motor has
failed to connect with the control unit. Unplug the main cable, check all
connections and try again.
ENGLISH
7.
8.
CONTROL PANEL
S. Setup button
1. Change to low position (default 70 cm / 27.5 in)
2. Change to middle position (default 95 cm / 37.4 in)
3. Change to high position (default 120 cm / 47.3 in)
Raise the desktop
Lower the desktop
10
FIRST USE
Plug in the power cord to the main outlet. Press and hold until the
display alternates "E1" and "rES", then release the button.
Press and hold again: the desktop will move slowly down and return
until the display shows "276”. The desk is ready for use.
Note: the anti-collision feature is not enabled during the reset, please
check that there are no obstacles.
Press the 1/2/3 buttons to change the height to the default
low/middle/high positions. Use the / buttons to manually raise
or lower the desktop.
Tip: the current desk height is indicated on the display in inches by
default. You can change this to centimeters instead. Refer to “Changing
the displayed unit” section to learn how to modify this.
To Next Page
Loading...
