wT 1255/12
Page 5
3 Proper Use
This product is exclusively intended to shut off or convey media within the approved
pressure and temperature limits after installation in a pipeline system. Please see the P/T
diagram (pressure temperature diagram) for the permissible threshold values in
accordance with the utilized materials. This operating manual must unconditionally be
brought to the attention of the corresponding personnel!
Prior to installation and putting into service for the first time, please read the operating
manual carefully and pay attention to the hazard and safety notes!
Non-compliance with the hazard and safety notes of this operating
manual may result in the creation of hazards and loss of the
manufacturer's warranty.
Please contact the manufacturer under +43 2252 600-0 for further
details.
Subject to technical alterations and misprints!
4 Testing of KLINGER Valves
KLINGER Valves are pressure-tested in accordance with EN 12266-1. The pressure test
comprises the tests P10, P11 and P12. Testing the resistance to pressure of the piston
(P20) is not included in the standard package.
5 Labeling of the Valves
Each valve is provided with the following data listed either on the body or on a type
plate.
Please see the operation manual for the
address
Manufacturer’s type designation
Numeric value in mm, e.g. DN 80 or in inch,
e.g. 3”
Numeric value for PN
/ class
Provides the max. permissible pressure at
ambient temperature, e.g. PN 40
FA-No. serves identification purposes
In accordance with material codes
To Next Page
Loading...
Need help?
General