25
5.4 Battery
5.Routine Maintenance
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To maintain
battery performance, keep the robot charged.
Note:
If the robot is to be left unused for an extended
period, turn it off before storage and charge it
at least once every three months to avoid battery
5.5 Firware Update
Update the robot using the app.
Place the robot on the dock station and ensure
that the battery level is higher than 20% before
updating.
damage resulting from over-discharging.
The power indicator will flash quickly during a
firmware update.
Environmental protection description
Removing the battery
The chemical substances contained in the built-in lithium-ion battery of this product can cause environmental pollution. Remove
the battery before disposing of this product and hand it to a professional battery recycling facility for centralized disposal.
1. Operate the robot until it has low battery and is unable to clean, ensuring it does not connect to the charging dock.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Pull out the battery connector and remove the battery.
Note:
•
Before removing the battery, make sure it is fully drained. Do not attempt to remove the battery if the robot is connected to the charging dock.
•
Remove the entire battery pack. Avoid damaging the battery pack casing to avoid short-circuits or leakage of hazardous substances.
•
In the event of accidental contact with battery fluid, rinse thoroughly with water and seek immediate medical care.
The following information applies only when disposing of the robot and should not be followed for day-to-day operations
*
To Next Page
Loading...