Klipsch CP-6 - Step 3: Final Connections; Connecting Speaker Wires; Securing Speaker to Bracket

STEP3
A.
A.
Connect Speaker Wires
to
Speaker Terminals with screwdriver
or
DRILL
SET
ON
LOWEST
TORQUE
SETTING
WITH
#2
PHILIPS
SCREWDRIVER
BIT.
Observe
the
correct polarity. Usually,
red
. wire. is positive (
+)
and black
is negative
(-
).
It
does
not
matter
which wire is connected
to
the
positive
or
negative terminal
as
long
as
the
connections are consistent. on
all
speakers in the
same system. Make sure both wires are pushed inside
slot
and
replace terminal
cover.
B.
IF
USING SUPPLIED BRACKET
B.
Once
speaker is positioned
as
desired push back
all
the way back
on bracket arms
until flush
with
bracket caps and screw
two
in·serted
screws
all
the way in
to
lock
position .