GETTING STARTED
1. Turn on the headset by pressing the Power/Pair button for 2 sec-
onds. The headset will automatically go to pairing mode and the
status indicator will begin pulsing BLUE.
2. Connect to “Klipsch On-Ear BT” from your device.
3. Once connected, the headset will periodically blink BLUE.
Note: The headset will automatically pair to the last device connected to it
when turned on.
TURNING OFF
Press the Power/Pair button for 5 seconds to turn the headset off.
CHARGING
Use the included Micro-USB cable to charge the headset from your
computer or USB wall adapter (not included). The status indicator will
glow RED until the headset is charged, at which point it will turn off.
To Next Page
Loading...