The remote control battery will need to be changed when it stops
working or when its performance is noticeably reduced. To remove
the battery, simply pull the battery housing tab from the remote
control (as shown in the diagram) and remove the battery. Replace
only with a 3-volt CR2025 lithium battery.
Changing the Remote Control Battery
Note: Lighting and other room conditions can reduce remote
performance.
The RoomGroove’s power supply has an integrated cable
management system. Excess cable length can be wrapped around
the power supply and secured with the rubber straps as shown in
the diagram.
Cable Management System and Mounting the
Power Supply
Your RoomGroove can be wall mounted with the optional wall
mount bracket available at Klipsch.com. Visit Klipsch.com or call
1.800.KLIPSCH (554.7724) for more details.
Optional Wall Mount Bracket
The RoomGroove’s power supply can be convieniently mounted
on the rear of the RoomGroove. To mount the power supply simply
position the hooks on the side of the power supply into the slots on
the rear of the RoomGroove as show in the diagram.
Slots
Hooks
5
To Next Page
Loading...
