10
G. Planned and unplanned uses
Planned uses
The MEPP consists of a carrier vehicle and the elevator which is an integral part of this machine.
It is designed for lifting people and tools according to indications; the maximum planned work
cycle of the MEPP is 100,000 cycles. According to the EN 280 standard, the 100,000 work cycles,
if executed on a regular basis for 10 years, should correspond to the following: use of machine
for 50 weeks/year, 40 hours per week, 5 cycles per hour.
The machine must be used by suitably trained personnel to guarantee absolute safety and avoid
any risks to third parties.
Unplanned uses
Any different use, not explicitly covered in paragraph II.L.1: Planned use
Cases where the manufacturer cannot be held liable
The Manufacturer is not liable in any of the following cases:
•
Uses not provided for in this manual.
•
Improper use of the machine or use by non-qualified persons.
•
Uses not complying with standards.
•
Lack of scheduled servicing.
•
Unauthorized changes or operations.
•
Removal of seals.
•
Use of non-original spare parts.
•
Failure to comply partly or fully with the instructions.
•
Failure to fill in or sign the service sheet (See chapter XI. Inspection register).
Load limiter
In standard form, our lifts are not equipped with load limiters, They correspond to the real for
stability criteria of standard EN 280. I.e., stability tests with 150% of the nominal load (static) and
110% of the nominal load (dynamic) with a smaller size bucket.
To Next Page
Loading...