Need help?Do you have a question about the KLUBB K38P and is the answer not in the manual?
Lists user manual and circuit diagrams.
Details about the elevator user manual and models.
Identifies intended users and technicians.
States copyright and usage restrictions.
Defines key terms like Qualified staff, MEPP, W.P., PTO, and Danger.
Presents size specifications and performance envelopes for models.
Details approved uses and limitations, and cases of manufacturer liability.
Describes the manufacturer's identification plate information.
Presents the CE compliance declaration and harmonized standards.
Outlines general warranty terms and service requests.
Information on contacting technical staff for support.
Guidance on how to use and maintain the manual.
Lists legal safety requirements and directives.
Specifies qualifications, training, and health requirements for operators.
Describes the types of safety plates affixed to the equipment.
Details general rules, prohibitions, and personal protective equipment.
Outlines pre-operation checks, vehicle positioning, and signaling.
Lists prohibitions and safety measures during operation.
Guidelines for safely concluding operations or taking breaks.
Specifies safety protocols for maintenance operations.
Identifies and labels key components of the elevator.
Checklist for pre-operation checks and vehicle traveling conditions.
Procedure for activating the emergency stop button.
Operation of the auxiliary pump when the main power fails.
How to override safety limits for emergency lowering.
Manual operation of hydraulic distributors on the turret.
Manual retraction/lowering of booms using actuator screws.
Visual checks for leaks, tires, oil, cables, and welds.
Checks for remote control, emergency pump, and shutdowns.
Checks for emergency power system and rotation lubrication.
Filter replacement, oil quality check, and pressure calibration.
Checklist for annual or 500-hour scheduled maintenance.
Information on recommended oils, filters, and pump cavitation.
Details on slew ring lubrication, greases, and frequency.
Note that shafts have self-lubricating bearings and need no lubrication.
States warranty depends on maintenance compliance.
Guidance for troubleshooting and contacting after-sales service.
Specifies qualifications for deactivation personnel.
Explains decommissioning requirements and liability.
Step-by-step instructions for dismantling and disposing of parts.
States no residual risk if procedure is followed.
Schematic diagram of the hydraulic system.
Placeholder for electrical circuit diagrams.
Instructions for filling out the control register.
Record of platform delivery and owner details.
Forms for recording ownership changes.
Log for recording part replacements.
Log for recording safety component replacements.
Log for recording maintenance activities.
Blank pages for user notes.
To Next Page
General