Klutch 49671 - User Manual

Questions and Answers

J
Jermaine YoungAug 1, 2025
What to do if the Klutch Cutter motor does not run?
- E
  Eric OconnorAug 1, 2025
  If the motor of your Klutch Cutter doesn't run or makes unusual breaking sounds, there might be several causes. First, check if the fuse is blown and replace it if necessary. A poor power contact could also be the issue, in which case you should replace the plug wire. Additionally, inspect the cable for any internal breaks, using a multimeter to locate the broken point. Finally, a breakdown in electric capacity could be the cause, requiring you to replace the electric capacity.
O
olsondanielAug 5, 2025
Why the Klutch 49671 cutting knife cannot cut?
- A
  Amy BrownAug 6, 2025
  If the cutting knife of your Klutch Cutter isn't cutting effectively, it could be due to a worn-out or dull blade; in this case, replace the blade. Another possibility is that the pin roll of the cutting knife is worn down, requiring replacement. Also, consider that applying too much force when starting to cut may be the issue; instead, cut with force.
E
Eric WalshAug 9, 2025
What to do if Klutch 49671 cooling oil cannot be sufficiently provided?
- A
  Angela RamirezAug 9, 2025
  If your Klutch Cutter isn't getting enough cooling oil, it could be due to a blocked oil circuit, so you should clean the oil circuit. Another potential issue is improper installation of the oil hole after removing the fulcrum shaft of the screwing die head; in that case, reinstall it. Lastly, check if the oil in the oil pump has leaked out, and if so, fill some cooling oil in the oil pump.
C
Charles ReyesAug 14, 2025
Why Klutch Cutter cutting knife does not work when threading?
- K
  Kathleen StaffordAug 14, 2025
  If the cutting knife of your Klutch Cutter isn't working when threading, it could be because the knife doesn't open widely when starting; ensure you use the knife properly. Alternatively, a few broken teeth on the cutter head may be the cause, requiring you to replace the knife. Also, the type and size of the knife might not be suitable, so reinstall the knife. Finally, check for iron filings in the grooves and clean the screwing die head if necessary.
C
Cassandra FrederickAug 18, 2025
What to do if Klutch 49671 pipe cannot be fastened?
- M
  Michael AlvarezAug 18, 2025
  If the pipe cannot be fastened or slips when threading with your Klutch Cutter, it might be due to less forceful stroke, so hammer with force. Another reason might be that the claw point is upside-down, so adjust the claw point. Also, check if one of the claw points is broken or notch-edged, and replace the claw point if needed.
W
william54Aug 22, 2025
Why does the Klutch 49671 Cutter main shaft heats up?
- M
  Michelle JacksonAug 22, 2025
  If the main shaft of your Klutch Cutter is heating up, it could be due to a lack of oil, so oil regularly. Alternatively, remove the beam barrel and scratch the shaft.
L
Leslie BarnesAug 27, 2025
What causes cooling oil leaks into the motor of Klutch Cutter?
- D
  Dana JamesAug 27, 2025
  If cooling oil is leaking into the motor of your Klutch Cutter, the oil seal of the oil pump PD8 x 22 x 8 has likely been damaged. Replace the oil seal to resolve this issue.