KMC Controls FlexStat Quick Reference Guide

FlexStat 1 Quick Reference Guide
Quick Reference Guide
DRAFT
NOTE: Watermark is
on nonwritable DRAFT
Watermark layer. Turn the
layer off or delete layer
to remove from the nal
document.
FlexStat
Controller/Sensor/Thermostat
Contents
Navigation .......................................................1
Room Temperature Setpoint Adjustment ..........1
Main Menu and Settings ..................................2
Schedules ......................................................... 2
Heat/Cool, Fan, Occupancy, and Override ......2
Navigation
Navigate the menus and change seings by press-
ing a combination of various arrow buons and the
(center round) Enter buon. Push the:
• Enter buon to select and/or exit value editing.
• Up or Down buon to move among entries.
• Right or Left buon to move among value elds.
• Left buon to return to the Home screen.
NOTE: Access to various functions may require a
password.
NOTE: See the FlexStat Operation Guide for
complete details on FlexStat conguration.
Room Temperature Setpoint Adjustment
From the Home (temperature display) screen, press
the Up or Down arrow buon once to view the exist-
ing setpoint.
To temporarily change the setpoint, press the Up
or Down arrow buon repeatedly until the desired
seing is displayed and press Enter. (If Enter is not
pressed, the display will return to the Home screen
after about ten seconds and the new setpoint value
will still be saved.) The new setpoint will hold until
the next schedule change.
To permanently change the setpoint for occupied
mode, go to the Setpoints section under the Main
Menu. (In the Setpoints menu, heating/cooling set-
points/setbacks and deadband can be changed with,
if required, the correct password access.)
WED 9/3 5:43 PM
COOL:
OCC:
FAN:
HUM: 31%RH
MAIN MENU
ABOUT
ADVANCED
ALARM
DATE/TIME
SCHEDULE
SETPOINTS
SYSTEM
SCHEDULE
ENTIRE WEEK [MON–SUN]
WEEKDAYS [MON–FRI]
WEEKEND [SAT–SUN]
INDIVIDUAL DAYS
HOLIDAYS
ENTIRE WEEK
1:
2: 5:15:00 PM OFF
3:
4:
5:
6:
[—>] DELETES ENTRY
7:30:00 AM ON
SYSTEM MODE
SYSTEM ENABLE:
AUTO
OCCUPANCY OVERRIDE
OCC OVERRIDE:
OFF
FAN MODES
UNOCC:
OCC: AUTO
AUTO
Override
Setpoint Adjustment
Home Screen
Override Screens
Configuration
Configuration Screens
Right
(Menu)
Left
(Override)
Down (Setpoint)
Up (Setpoint)

KMC Controls FlexStat Specifications

General

Brand	KMC Controls
Model	FlexStat
Category	Thermostat
Language	English