Knight KLE175GT - User Manual

Questions and Answers

S
Samantha HuertaJul 31, 2025
What to do if the Knight KLE175GT Dishwasher chemical injection is bad?
- A
  Ann ShortJul 31, 2025
  If the chemical injection (detergent, rinse, sanitizer) is not working correctly, there could be several reasons. You may not have enough chemical; in that case, adjust the pot (time settings). There could be poor chemical flow, so replace the pump squeeze tube. A faulty chemical pump motor could also be the reason; replace the chemical pump motor. Finally, check if the product container is empty.
Z
Zachary HoffmanAug 5, 2025
Why my Knight KLE175GT Dishwasher will not start?
- T
  Tracy MartinezAug 5, 2025
  Your Knight Dishwasher might not start due to several reasons: the door might be open, the run power switch might be off, there might be no supply voltage, or the delime switch might be on. Also, check if the 3/8 amp fuse to the transformer is blown and replace it if necessary.
T
Tyler MorseAug 10, 2025
How to fix low spray arm pressure on a Knight KLE175GT Dishwasher?
- M
  Monique CookAug 11, 2025
  If your Knight Dishwasher has low or no spray arm pressure, it could be due to several factors. The impeller might be clogged; remove the pump face and clean the impeller. Also, the pump intake tube could be clogged; remove the pump face and push debris out of the pump intake tube. The spray arm or spray tips could also be clogged; remove the spray arm and clean it. Finally, the water level could be low; fill the tank to the proper level.
T
tduffyAug 15, 2025
Why does the wash pump motor run continuously on my Knight KLE175GT?
- X
  xstoutAug 15, 2025
  If the wash pump motor runs continuously on your Knight Dishwasher, it could be due to a few reasons. The delime switch might be on; turn the delime switch off. A faulty circuit board could be the cause. The motor relay might be stuck; tap on the relay.
K
Kelly CastilloAug 20, 2025
How to improve reduced wash results with a Knight KLE175GT Dishwasher?
- G
  gilesnicholasAug 21, 2025
  If you're experiencing reduced wash results with your Knight Dishwasher, consider these potential causes: the spray arm bearing may be worn, in which case you should replace the bearing. The washer may not be level, so level it with bullet feet. Also, the tray rails might be damaged; replace the tray rails.
A
Allen AlvarezAug 26, 2025
What to do if the vacuum breaker on my Knight KLE175GT Dishwasher is leaky or noisy?
- J
  Jared TrevinoAug 26, 2025
  If the vacuum breaker on your Knight Dishwasher is leaky or noisy, it could be due to water pressure issues. If the water pressure is too low, clean the screen. If the water pressure is too high, adjust the fill pressure.