SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble or operate this
product, failure to follow may result in serious injury. Save all warnings and instructions for future
reference.
• Do not stand on, step on, or alter this unit for anything outside the designed function of storage.
• Use care when handling and assembling metal parts.
• The metal may have sharp edges or corners. The use of protective gloves is recommended.
• Always remember to use proper lifting techniques when moving the boxed or assembled unit.
• Do not exceed 1500lbs per shelf. Be aware of dynamic loading! Sudden load movement may
briefly create excess load causing product failure.
• Evenly distribute the weight on each shelf and keep the heaviest loads on the bottom shelf.
• Use only on flat, level and hard surface capable of supporting the shelving and any items placed
on it. Maintain proper footing and balance at all times.
• Do not store flammable liquids in the unit unless they are secured in an approved container.
• Do not store gasoline in the unit under any circumstances.
• Keep bystanders out of the area during assembly.
• This product is not a toy. Do not allow children to play with, on or near the unit.
• The steel bottom feet are designed with mounting holes in the middle, with a diameter of 21/64"
(8.5 mm). You could secure the shelving unit to the floor with 15/64" (6 mm) to 5/16" (8 mm)
bolts/washers/expansion tubes (not included), if needed.
CAUTION
WARNING
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for replacement parts.
It is recommended that this product to be assembled on a clean, soft surface, such as a piece of
cardboard.
The assembling task can be performed by one person but availability of a second person will make
the task simpler.
Estimated Assembly Time: 15 minutes (does not include unpacking time)
Tools Required for Assembly (included): 4 mm Hex Key, 10 mm Wrench
Tools Required for Assembly (not included): Rubber mallet
PREPARATION
4
To Next Page
Loading...
Need help?
General
