9
PREPARATION
• Slide the blower tube (B) over the slot (E) until the
lock button (F) on the blower is inserted into the
slot. Press the safety button (G) to remove the
blower tube.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
ASSEMBLY INSTRUCTIONS
WARNING
To prevent accidental starting that could cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
ASSEMBLING THE BLOWER TUBE
IMPORTANT:
The battery pack is not fully charged when it is purchased. Before using the blower for the rst time,
place the battery pack in the battery charger and fully charge the battery.
WARNING
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or re:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the charger manual.
SAFETY INFORMATION
1
E
G
B
F
To Next Page
Loading...
Need help?
General
