11
OPERATING INSTRUCTIONS
6. 4-position adjustable handle
Rotate the handle knob (E) and position handle to
one of the three operating positions.
Tighten the handle knob to secure the handle in
place.
WARNING
Before sanding small workpieces, ensure that the
workpiece is securely held in a vise or clamp.
7. Dust-collection bag
When sanding, attach the dust-collection bag (I) to
the sander.
• To install: Align the edge of dust port (H) with the
slot of dust-collection bag outlet. Insert it into the
tool until it is rmly seated.
• To remove: Lift the dust-collection bag outlet up,
and gently pull on the dust bag.
• To clean the dust-collection bag: Empty the
dust-collection bag by unzipping the lock located
on the bottom of the bag, then gently tap the
dust-collection bag to remove the dust.
For longer periods of use or on large pieces of
work, attach a vacuum cleaner to the adaptor.
The sander can be connected to a 1-1/4in. diameter vacuum hose to help keep the work area
clean. Wear a suitable dust mask, as there still may be some residual airborne dust particles in
the work area.
WARNING
• Do not use the dust-collection bag when sanding metal, which may cause re.
7
I
H
6
E
Storing position
To Next Page
Loading...
Need help?
General
