12
CARE AND MAINTENANCE
WARNING
In order to avoid personal injury and the risk of re and electric shock, remove the battery pack before
adjusting, inspecting, or cleaning the blower.
CLEANING
• Remove the battery pack.
• Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Keep
the air vents free of obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the
air vents in water.
• Wipe off the housing and the plastic components using a moist, soft cloth. Do not use strong
solvents or detergents on the plastic housing or plastic components. Certain household cleaners
may cause damage, and may cause a shock hazard.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Unit will not blow. 1. Blocked tube. 1. Clear the blockage.
Motor fails to start
when switch trigger
is depressed.
1. Battery is not secure.
2. Battery is not charged.
1. Ensure the battery is fully secure in
the battery compartment and the
battery release button locks into
place.
(Reference Page 10 of the
instruction manual).
2. Charge the battery pack according
to the instructions included with
your model.
Unit will not start.
1. Defective power switch. 1. Return to place of purchase or re
turn the unit to a repair center or
call customer service at
1-888-3KOBALT (1-888-356-2258).
To Next Page
Loading...
Need help?
General
