9
kobalttools.com
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or re:
• Replace the battery or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery is removed before inspecting, adjusting, or performing maintenance on any
part of the blower.
• Read, understand, and follow the instructions contained in the charger manual.
WARNING
ASSEMBLY INSTRUCTIONS
1. Starting/stopping the blower
a. Press the power button (F) located on the blower.
You will hear two audible beeps signaling the
blower is active.
b. Squeeze the trigger switch (H) to start.
c. To change speeds, press the fan button (I) to the
right of the power button (F). Lights will illuminate
showing the current setting.
d. Release the trigger switch (H) to stop.
e. After the job is complete, press the power button
(F) to turn off the blower.
Note: The current speed setting will remain even if
the unit is turned off.
1
H
F
I
OPERATING INSTRUCTIONS
2
2. Battery
IMPORTANT: The battery is not charged when it
is purchased. Before using the blower for the rst time,
place the battery in the battery charger and charge.
Make sure to read all safety precautions and follow the
instructions in the battery and charger manuals.
To install the battery:
1. Align the battery (C) with the battery opening.
2. Insert the battery into the battery opening until the
battery release button (E) locks into place.
3. Push down on the battery until it locks into place. You
should hear a “click” once it is installed.
To remove the battery:
1. Press the battery release button (E) on the blower.
This will cause the battery to slightly protrude out of
the tool.
2. Grasp the blower rmly and pull the battery out of the
handle.
C
E
To Next Page
Loading...
Need help?
General
