To Next PageTo Next PageWhat to do if bit cannot be installed in Kobalt Power Tool?
If you're unable to install a bit in your Kobalt Power Tool, there are a couple of potential reasons: * The chuck may not be released. Make sure to release the chuck. * The bit may not fit the chuck. Use an appropriate bit or a suitable adaptor.
What to do if the LED worklight on my Kobalt Power Tool blinks rapidly?
If the LED worklight on your Kobalt Power Tool is blinking rapidly, it indicates that the tool has stopped working to protect its internal circuits. To resolve this, release the trigger switch, allow the tool to cool down, and then restart it.
Why is the LED worklight blinking slowly on my Kobalt Power Tool?
If the LED worklight on your Kobalt Power Tool is blinking slowly, it means the battery charge is very low. Charge the battery to solve this problem.
General| Battery Compatibility | Kobalt 24V Max batteries |
|---|---|
| Voltage | 24V |
| Input Voltage | 120V AC |
| Output Voltage | 24V DC |
| LED Indicators | Yes |
| Charge Time (2.0 Ah battery) | 30 minutes |
| Charge Time (4.0 Ah battery) | 60 minutes |
| Charging Time | Varies by battery capacity |
Follow all warnings and instructions to avoid electric shock, fire, or serious injury.
Stay alert, use PPE, prevent unintentional starting, do not overreach, dress properly.
Use auxiliary handle, secure workpiece, hold with both hands for control.
Wear ear protection. Secure workpiece. Set direction to lock.
Read all instructions. Recharge with specified charger. Handle battery safely.
Crucial safety guidelines to reduce fire or electric shock risks.
Familiarize with operating features and safety requirements before use.
Familiarize with operating features and safety requirements before use.
Familiarize with operating features and safety requirements before use.
Instructions for attaching and detaching the battery pack for operation.
How to turn the tool ON/OFF and use variable speed.
How to select between low and high speed settings.
General instructions for drilling, including wood and metal techniques.
Instructions for driving screws, including pilot holes.
How to select between three speed ranges for the impact driver.
How to use the power indicator to check charge status.
Steps to charge the battery pack.
How to clean the tool safely and properly.
How to clean the battery pack safely.
How to clean the charger safely.
