4
2. Checking the charge
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool. Make sure that the outlet is not turned off.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the air temperature is above 104˚F (40°C) or below 45˚F (7°C), move the charger and battery
pack to a room temperature location.
OPERATING INSTRUCTIONS
Note: If the battery and the charger won’t be used for a long time, remove the battery from the charger
and pull out the AC power plug.
If the battery is inserted into the charger when warm or hot, the charging LED indicator light on the
charger may switch on and illuminate RED. If this occurs, allow the battery to cool inside of the
charger. The battery will begin charging once it has returned to charging temperature.
WARNING
Battery storage:
If the battery will not be used for 3 months or more, please store the battery in a room temperature
environment. Please fully charge before storage.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of the battery.
Once it is fully charged, the next charge will return to standard charging.
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from
the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly
charging. If the status LED is still blinking RED, remove the battery and unplug the charger for 1 minute.
After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks GREEN, then the
battery is properly charging. If the status LED is still blinking RED, the battery is defective and needs to
be replaced.
To Next Page
Loading...
Need help?
General
