MISPLACING YOUR PARENT UNIT
In the case that you misplaced your Parent
Unit somewhere in your house, you can
page the Parent Unit with your Base Unit.
Click on the round button located on the
Base Unit, directly behind the Camera.
Your Parent Unit will emit a chime. Once you
locate your Parent Unit, tap the top blinking
light to turn off the page. The chime will turn
off automatically after 1 minute.
LED INDICATORS
Base Unit!
Red Powered off.
Green Powered on and
functioning normally.
Flashing
Orange
Base Unit and Parent Unit
are not paired.
Flashing Green Base Unit and Parent Unit
are in the process of
pairing.
Parent Unit!
Green Powered on and
functioning normally.
Flashing Red Low battery.
Red Charging.
Flashing
Orange
Base Unit and Parent Unit
are not paired, or Parent
Unit is powered off.
Flashing Green Base Unit and Parent Unit
are in the process of
pairing.
For troubleshooting help, visit our FAQ section at
https://KODAKsupport.zendesk.com or contact us directly at
KODAKsupport@isecurityplus.com.!
Camera!
Green Connected to iSecurity+
servers.
Orange Home network connection
issue. Please check your
home router or modem.
Flashing
Orange
Not connected to the
internet. If you have not
set up your camera,
please follow the setup
instructions in this manual.
If your Camera was
operating normally, please
check your outgoing
internet connection.
To Previous Page
Loading...
