Page | 38 Troubleshooting
Power Indicator on the Parent Unit does not come on
• Check whether the Parent Unit is powered on.
• Check whether the battery is charged.
• Recharge the Parent Unit by connecting it to the
power supply.
The Parent Unit beeps repeatedly
• The Parent Unit and the Baby Unit may be out of
range with each other.
• Reduce the distance between the units, but not
closer than 3 feet.
• The Baby Unit may be switched o. Slide the ON/
OFF switch to the ON position to switch on the
Baby Unit.
• The battery in the Parent Unit is running low.
Connect the Parent Unit to an electrical outlet with
the supplied power adapter for recharging.
7. TROUBLESHOOTING
The Battery icon on the Parent Unit lashes
• Battery pack in the Parent Unit is running low.
Connect the Parent Unit to an electrical outlet with
the supplied power adapter for recharging, the
parent unit will beep when its battery is running
low.
Unable to hear sound or baby crying from the Parent Unit
• The volume level in the Parent Unit may be set too
low. Refer to section 4.9 for volume level settings.
• The Parent Unit and the monitoring Baby Unit
may be out of range with each other. Reduce the
distance between the units, but not closer than 3
feet.
The baby monitor system produces a high-pitched noise
• The Parent Unit and the Baby Unit are too close to
each other. Make sure the Parent Unit and Baby
Unit are at least 3 feet away from each other.
• The speaker volume of the Parent Unit may be set
too high. Decrease the volume of the Parent Unit.
To Next Page
Loading...
