Page | 40 Troubleshooting
Battery life in the Parent Unit runs low quickly
• The LCD brightness may be set too high. Try to
decrease the brightness level. Refer to section 4.7
for details.
• The volume level of the Parent Unit may be set too
high, which consumes power. Decrease the volume
level of the Parent Unit. Refer to section 4.9 for
volume level settings.
Parent Unit image is not in color
• The Baby Unit is in a dark room, which causes the
infra-red illumination to turn on and the picture
image to change from color to black and white.
When the room becomes brighter, the picture will
return to color.
There is no transmission from the Baby Unit to the
Parent Unit
• Switch on both the Baby and Parent Units.
• Pair the Baby Unit again as described in see
“4.2.1 Add (Pair) a Camera”.
• If there is no free camera location, delete a
location irst, as described in see “4.2.2 Delete a
Camera”.
The Parent Unit is in standby
• To turn on the Parent Unit screen, slide the ON/
OFF switch to the ON position.
To Next Page
Loading...
