Kodak EasyShare M820 - Manually changing USB connection mode

Doing more with your frame
www.kodak.com/go/support
15
Manually changing USB connection mode
The connection mode must match the device you connect the frame to: Computer or
Printer. The default is Connect to computer. You can change the connection mode
manually.
1 Disconnect the printer or computer from the frame.
2 On the frame, tap (Home).
3 Tap (Settings).
4 Slide to highlight Device configuration, then tap OK.
5 Highlight USB connection mode, then tap OK.
6 Slide to highlight the mode you want to connect to, printer or computer, then tap
OK.
7 Reconnect the device (printer or computer) that matches the connection mode.