Kodak EP101WG - Main page

12:30
12:30
Press to add new system
For New Camera
Please Plug in The Power Cable.
It Takes About 1 Minute to Reboot.
For Existing Camera
12:30
Camera added successfully!
Manage WiFi network
OK
Kodak-wi
Signal strength: 82%
Security: WPA2 TKIP
Wireless password:
Show password.
12:30
Camera added successfully!
OK
APP INSTALLATION / ANDROID
EN
1 From your smart device, download and install
the free KODAK Security Application
2 Tape « + » on screen for direct wireless
connection of the camera to the application.
3 Plug the camera into an electrical outlet
(allow the camera up to 90 seconds to boot up).
4 The App will start the connection process.
5 Once found, the Change Password screen will
appear Enter a password and remember it or
write it down for future use.
Tape « OK ».
6 The Setup Wi-Fi Network pop-up box will appear.
Select your home network from the menu, and
then enter your home network’s Wireless Password.
Tape « OK ».
7 The screen shows that the camera has been set up
successfully.
Tape « OK ».
8 You will find your camera in the list of cameras
of your application. Wait 90 seconds for the
camera to appear connected.
9 Tap image for live video.
12:30