8
9. Press the ilm down near the fourth tab and make sure the ilm clips in place.
10. Press your inger down once more on the ilm to make sure the ilm is under all four (4) tabs.
A click should be heard when the ilm is probably under each tab.
NOTES: If the ilm is placed into the slot correctly, the gray pin will automatically adjust itself
into the correct position when recording begins.
7. Hold the ilm irmly in between your pointer inger and thumb. Slowly place the ilm under
the irst black tab (tab farthest left in the ilm area). Then, carefully twist the ilm and place
it under the second black tab in the ilm area.
8. Twist the ilm slightly again to it the ilm under the third tab.
When loading a new ilm into the ilm scanner, your ilm may appear out of frame
when irst on screen. To properly center and position your ilm correctly,
slide the ilm type switch back and forth once. By sliding the ilm type switch back
and forth, the reel on the reel shaft will spin moving the ilm into its proper position.
When using 8 mm ilm, slide the switch over to the Super 8 ilm selection then back
over to the 8 mm ilm selection. When using Super 8 ilm, slide the switch over to the
8 mm ilm selection then back over to the Super 8 mm ilm selection.
To Next Page
Loading...
