Kodak REELZ - Port Panel Overview; Film Installation Guide

7
8. PORT PANEL OVERVIEW
9. FILM INSTALLATION
1. SD™ card slot
2. MICRO USB slot
3. DC 12 V port
1
2
3
1. Unfold the two (2) reel shafts until they click into place.
2. Carefully pull out the end of the ilm on your 8mm or Super 8 reel (not included). Then, fold
up the end of the ilm nice and tight and slowly insert the end of the ilm in the slot on the
empty reel (included). This process will help you connect your ilm to the empty reel.
3. Spin your empty reel around a few times to make sure your ilm is now securely connected to
the empty reel.
4. Insert your reel onto the left reel shaft and place the empty reel onto the right reel shaft.
(If the reel you’re using has a big mounting hole, use the provided red color reel adapter. If
adapters are needed, always place red color adapter on the left reel shaft; gray color adapter
on the right reel shaft.)
5. Take the ilm between the two (2) reels and carefully thread it through the scanner. Use the
white, solid line on the ilm scanner to follow how to thread the ilm on the ilm spools.
6. Push the ilm lid tab to the left to lift the ilm lid and gently wipe down the ilm area with the
cleaning cloth (included) before placing the ilm.