www.kodak.com/go/Zm2support 17
4 Appendix
Safety
Do not disassemble this product; there are no user-serviceable
parts inside. Refer servicing to qualified service personnel.
KODAK AC Adapters and battery chargers are intended for indoor
use only. The use of controls, adjustments, or procedures other
than those specified herein may result in exposure to shock
and/or electrical or mechanical hazards. If the LCD breaks, do not
touch the glass or liquid. Contact Kodak customer support.
■
The use of an accessory that is not recommended by Kodak may cause fire, electric
shock, or injury. For approved accessories, go to www.kodak.com/go/Zm2accessories.
■ Use only a USB-certified computer equipped with a current-limiting motherboard.
Contact your computer manufacturer if you have questions.
■ In the unlikely event that battery fluid leaks onto your skin, wash immediately with
water and contact your local health provider. For additional health-related information,
contact your local Kodak customer support.
■ Go to www.kodak.com/go/reach for information about the presence of substances
included on the candidate list according to article 59(1) of Regulation (EC) No.
1907/2006 (REACH).
■ If using this product in an airplane, observe all instructions of the airline.
■ For more information, go to www.kodak.com/go/batteries.
Care and maintenance
■ Before inserting or removing a card, make sure your hands, the camera, and the card
are completely dry.
■ If water has entered the camera, remove the card. Allow all components to air-dry for at
least 24 hours before using the camera.
■ Wipe off dirt or sand from the door seals—debris could compromise the seal and cause
a leak in water.
To Next Page
Loading...
