Koenic KWM 62212 A3 - Filter Maintenance and Cleaning; Cleaning the Lye Pump Filter; Inlet Water Filter Maintenance

27
English
Fig.
12
Clean the filter of the lye pump
Caution
• Never operate the washing machine
without a filter.
• The filter of the lye pump prevents foreign
objects from aecting the pumping
system.
• Clean or check the filter regularly
depending on the frequency of use,
approximately once a month.
• Check the filter if the water is not pumped
out or if the noise is increased during
pumping.
• Before opening the service flap, place
a big cloth in front and below the flap.
Large amounts of water may leak when
removing the filter.
• Make sure that all water has been
pumped out during the previous
wash cycle and then turn o the
power and unplug the power cord.
• Place a collecting tray in front of it to
catch any leaking water.
• Open the maintenance flap.
• Turn the filter cover to the left. Catch
leaking water!
• Clean the filter under running water.
• Insert the filter and turn it to the
right. Make sure that the filter is
properly fastened so that no water
can leak.
• Close the maintenance flap.
Fig.
13
Inlet filter
Caution
• Close the water supply!
• After cleaning, always make sure that the
water hose is properly installed and no
water leaks.
Filter at the tap
Clean the filter if there is an insucient
flow of water when the water tap is
open.
• Unscrew the supply hose from the
water tap.
• Wash the inlet filter under running
water.
• Reconnect the supply hose.
Supply filter of the washing
machine
Clean the filter regularly, approximately
every three months.
• Unscrew the supply hose on the back
of the unit.
• Clean the filter with a small brush.
• Reconnect the supply hose.
IM_KWM62212-A3_191107_V09_HR.indb 27 8/11/2019 10:11