To assemble the tap mechanism until you hear a “Ka” sound that will
indicate the tap mechanism fixes on the beer keg. (Show as figure
10)
Figure 10 Figure 11 Figure 12
3. Open the beer cooler with 60-80N strength and place the
well-assembled keg into the cooling cavity; Connect the CO2
connector tube and beer outlet tube with the keg lifter tube
connector.
NOTES: make sure all connection of tap mechanism is well
connected, and without damage. And make sure tap valve is on
close status, and the CO2 pressure regulator knob is at “Off” status.
Figure 13 Figure 14
4. Loosen the CO2 bottle sheath (Show as figure 15), insert a
16gram CO2 cartridge in the sheath (Figure 16), and screw the
sheath tightly until you will hear a “Click”(Figure 17), which indicates
that the cartridge seal has been pierced and the CO2 gas can flow
into the keg freely. Make us the bottle sheath is fixed tightly to avoid
the CO2 leakage. Then put CO2 bottle sheath into the top cover.
To Next Page
Loading...