Koenig bw1880 - User Manual

Questions and Answers

A
Andrea SharpJul 27, 2025
Why is there too much foam when pouring beer from my Koenig bw1880?
- K
  Kristin MontoyaJul 27, 2025
  Excessive foam when pouring beer from your Koenig Freezer can occur for several reasons. It could be due to an incorrect pouring technique, or the beer temperature might be too high; ideally, it should be between 3-5°C. Shaking the keg before use, having almost no beer left in the keg, or excessive pressure within the keg can also cause this issue. To resolve this, try using the correct pouring method, cooling the beer to the recommended temperature, letting the keg sit until the bubbles dissipate, replacing the keg, or adjusting the pressure knob to decrease the pressure.
J
Jennifer MataAug 6, 2025
What to do if the tap on my Koenig bw1880 isn't pouring beer?
- J
  Joseph LaneAug 6, 2025
  If the tap on your Koenig Freezer isn't dispensing beer, several factors could be at play. First, ensure the pouring tube is properly connected and the CO2 supply isn't cut off. Also, check if the keg is empty or needs replacement. Verify that the CO2 cartridge has gas and that the CO2 pressure regulator knob is in the "+" position. If any of these are not correct, adjust or replace them accordingly.
R
riveraashleyAug 15, 2025
How to fix slow beer flow from my Koenig Freezer?
- C
  Carol JohnsonAug 16, 2025
  If beer is flowing too slowly from your Koenig Freezer, it could be due to insufficient CO2 pressure or a leak in the connection or pouring tube. Try adjusting the pressure knob to increase CO2 pressure or replace the CO2 cartridge. Also, inspect the tubes for leaks and replace them if necessary.