This document is a user guide for the Kogan 1500W White Glass Portable Electric Panel Heater, model KAHTP15WHTA.
Function Description:
The Kogan 1500W White Glass Portable Electric Panel Heater is designed to provide heating for indoor spaces. It can be used as a free-standing unit or wall-mounted. The heater offers various operating modes, including ECO mode, Comfort II power, and Frost-free mode, allowing users to control the heating output and energy consumption. It features an LCD screen for displaying settings and status, and can be controlled via operation buttons on the unit or a remote controller. The heater is equipped with a safety device to prevent overheating.
Important Technical Specifications:
- Model: KAHTP15WHTA
- Rated Voltage: 230V~
- Frequency: 50/60Hz
- Rated Power: 2000W
- Protective Class: 1
- Heating Power: 1500W (as indicated in the product title, though the specifications table lists 2000W for "Rated Power" which might be a general rating for the product line or a maximum power draw. For this specific model, 1500W is highlighted in the title).
- Temperature Setting Range: 15°C to 50°C
- Frost-free Mode Temperature: Fixed at 5°C
- ECO Mode Temperature: Fixed at 18°C
- Timer Function: 0-24 hours
Usage Features:
Assembly:
The heater can be set up in two ways:
- Free Standing: Attach the two plastic feet to the bottom of the heater using a screwdriver and 4 provided screws per foot. Ensure the heater is placed on a flat, stable surface.
- Wall Mounting:
- Remove wall brackets and expansion screws from the packaging.
- Fix the screws to the wall according to the distances between the holes of the wall brackets.
- Aim the 4 holes in the back of the heater to the 4 hooks on the wall bracket, push it on, and slide them into the slots to click.
- Fix the wall bracket lock piece onto the bracket with screws, slide it into the locking slot on the back of the heater, and tighten the screw.
- Minimum distances must be maintained from ceilings (60cm), ground (60cm), and sidewalls (30cm) to ensure proper airflow and avoid hazards. Wall mounting should be performed by a qualified person.
Operation:
- Connect the heater to a power socket and switch on the ON/OFF switch on the side panel.
- Use the operation buttons on the unit or the remote control to set heating parameters.
- Press the power button on the heater to enter Standby Mode and Frost-Free mode.
- Press the "POWER" button to set to ECO mode (displaying "Economic I") or alternately to Comfort II power or Frost-free mode.
- Flashing icon indicates ECO mode.
- Flashing icon indicates low power.
- Flashing icon indicates high power.
- Flashing icon indicates frost-free mode.
- Under heating status, a "wavy lines" icon will appear on the LCD screen. In Frost-free status, if the ambient temperature is higher than 5°C, the heating icon will disappear.
Setting Temperature:
- Temperature can be set only in Comfortable or Economical mode. ECO and Frost-free modes have fixed set temperatures (18°C and 5°C respectively).
- Press the "TEMP" button, then use the UP/DOWN buttons to set the temperature between 15°C to 50°C. The setting is memorized and confirmed after 10 seconds.
- The set temperature must be higher than the ambient temperature for the unit to function.
- Automatic mode switching:
- If ambient temperature equals preset temperature, power switches from Comfortable to Economical mode.
- If ambient temperature is 2°C higher than preset temperature, the heater stops heating.
- If ambient temperature is 2°C lower than preset temperature, the heater switches to Comfortable mode again.
Timer Setting:
- Press the "TIMER" button, then use UP/DOWN buttons to set the timer from 0-24 hours.
- When the timer is active, a "clock" symbol will flash. The setting is memorized and confirmed after 10 seconds.
- If the timer is set while the heater is running, it will switch the heater OFF after the set duration (e.g., setting to 01:00 will switch it off after one hour).
- Timer functions can be achieved using both the remote control and the control panel.
Safety Warnings:
- Ensure voltage matches rating plate.
- Do not operate with damaged cable or plug.
- Keep away from heat, sharp objects, and anything causing damage.
- Damaged cord must be replaced by Kogan.com.
- Switch off before connecting to mains.
- Switch off and unplug when not in use, cleaning, or maintenance.
- Do not pull the cord to disconnect.
- Do not locate immediately below a power socket.
- Do not operate near fuel, paint, or flammable liquids.
- For indoor use only.
- Do not cover to avoid overheating.
- Do not block air intakes or exhaust vents.
- Do not touch hot surfaces directly.
- Do not insert foreign objects into vents.
- Ensure hands are dry when operating or touching plug/socket.
- Not for use by persons with reduced physical, sensory, or mental capabilities or lack of experience/knowledge unless supervised.
- Children must be supervised and should not play with the heater.
- Do not leave unattended when in use.
- Regularly remove dust/fluff from air vents/grilles by vacuum cleaning after disconnecting from power.
- Do not place on carpet or place cable under carpets; arrange cord away from traffic areas.
- Do not use near a bath, shower, or swimming pool.
- Store in a cool, dry location after cooling down.
- Do not use if the glass panel is damaged.
Warning - Keep Batteries Out of Reach of Children:
- Swallowing button batteries can cause serious injury or death.
- Call Poisons Information Centre immediately if ingestion is suspected.
- Ensure battery compartment is secured; do not use if not secure.
- Dispose of used button batteries safely.
- Inform others about the risk.
Maintenance Features:
Cleaning & Care:
- Always disconnect and allow the heater to cool completely before maintenance.
- Use a vacuum cleaner to remove dust and fluff from the grilles.
- Clean the outside with a soft damp cloth, then dry with a dry cloth. Never immerse in water or let water drip into the unit.
Overheating Safety Device:
- The heater is fitted with a safety device that switches it off if it overheats.
- If triggered, turn off, unplug, and let it cool completely.
- Inspect for blockages of air inlets or outlets before attempting to restart.
- If the heater fails to operate or the safety device triggers again, contact Kogan.com customer support.
Storing:
- Always disconnect, allow to cool, and clean before storing.
- If storing for an extended period, place the unit back into its original carton and store in a dry, well-ventilated location.
- Do not place heavy items on top of the carton during storage to avoid damage.
Disposal:
- The product marking indicates that it should not be disposed of with household waste.
- Recycle responsibly to promote sustainable reuse of material resources and prevent harm to the environment or human health from uncontrolled waste disposal.
Need help?
General
To Next Page