**订购时请说明颜色编号
**Color code must be specified when ordering
安装步骤
INSTALLATION
清洗说明
CLEANING INSTRUCTIONS
适用于所有加工处理过的表面：以中性肥皂水清洗
镀层表面，再以干净的软布彻底擦干整个表面，许
多清洁剂，比如氨水、去污粉及洁厕灵等，会对电
镀表面造成伤害，切忌使用。
有磨损性的清洁用具或清洁剂也不可使用于科勒牌
的水龙头及其配件上。
All Finishes: Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals,
such as ammonia, chlorine, toilet cleaner etc. which
could adversely affect the finish and are not
recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler
faucets and fittings.
零件图
SERVICE PARTS
切勿在此时将保护套(1)移去。
连接螺纹为G1/2˝的供水管(2)至混合栓进水处(3)。
供水管路中心线与装修好的墙面之间距离应为51mm
至63mm。贴红点一侧朝左，安装热水管。
Do not take off the protectors(1) at this moment.
Connect the G1/2" water supply pipes(2) to the supply
yoke(3).
The distance from centerline of the water supplies to
the surface of the finished must be between 51mm and
63mm. Make sure the left supply pipe is the hot supply
and connected to the end with red mark.
1443561-T2-B 2
1
3
2
3
51~63mm
The finished wall
装修好的墙面
Valve(Cold)
Valve(Hot)
31141T-NA
SKU Valve(Hot)
835750
835749
Valve(Cold)
835749
835750
34667T-NA
To Previous Page
Loading...
Need help?
General
