18-5/8"
(473 mm) -
19-3/8"
(492 mm)
8-5/16"
(210 mm)
15-9/16" (395 mm)
Electrical Service Detail
32" (813 mm) R.
6" (152 mm) Min
2"
(51 mm)
1-1/4"
(32 mm)
Min
5-1/2"
(140 mm)
13-1/4"
(337 mm)
Min
4-3/4"
(121 mm)
11-7/16"
(291 mm)
20-11/16"
(525 mm)
16-3/16"
(411 mm)
16-15/16" (430 mm)
1-7/16"
(36 mm)
Notes
Required Electrical Service
Install this product according to the installation
guide.
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI). Outside North America,
this device may be known as a Residual Current Device (RCD).
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi - 80
psi (139 kPa - 551 kPa).
120 V, 15 A, 60 HzBidet toilet seat:
Technical Information
Do not install this seat in a location where: (1)
water might be splashed on the product or (2)
All product dimensions are nominal.
ElongatedSeat shape type:
excessive moisture, high humidity levels, or
condensation is present. This will avoid damage
to the electronic components.
Closed-frontSeat front type:
5-1/2" (140 mm)Seat-mounting holes:
Do not use an extension cord with this product.
Bidet toilet seat: 120 V, 15 A, 60 Hz, 1800
W
Electrical component
rating:
To avoid possible product malfunction, do not
plug in the seat until instructed to do so.
43" (1092 mm)Power cord length:
Locate the recepticle at least 6" (152 mm) above
the floor, and within a 32" (813 mm) radius
measured 2" (51 mm) from the bowl ledge.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
10-18-2019 05:38 - US/CA
C³
®
-050
elongated cleansing toilet seat
K-18751
To Previous Page
Loading...
Need help?
General