How to fix a Kohler toilet that does not flush?
If your Kohler toilet does not flush, first ensure that the water supply to the toilet is turned ON. If the water supply is on, the toilet may be blocked, so use a plunger to remove the blockage; for extreme blockage, a snake may be used. If the problem persists, the remote control may not be working properly.
How to fix the seat cover if it does not open automatically on my Kohler toilet?
If the seat cover on your Kohler toilet does not open automatically, first, ensure that the cover open/close feature is enabled. If it is enabled, adjust the cover open/close sensor distance using the remote control, as the motion sensor might be set at far distance.
Why does my Kohler toilet not flush automatically?
If the toilet does not flush automatically, it may be because the automatic flush feature is not enabled. Alternatively, the user may not be detected by the sensor, in which case you should flush the toilet using the remote control.
Why does the bowl of my Kohler toilet contain little water?
If the toilet bowl of your Kohler toilet contains little or no water, it may be because the water has evaporated during an extended period between uses. Flush the toilet to refill the bowl.
How to troubleshoot a Kohler toilet with no power?
If your Kohler toilet has no power, first, press the power icon on the toilet control panel. If that doesn't work, ensure the power cord is securely plugged into a GFCI or RCD electrical outlet. Finally, check if the Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD) has tripped and reset it if necessary.
What to do if there is low water flow from the spray wand on my Kohler toilet?
If you experience low or no water flow from the spray wand of your Kohler toilet, ensure the water supply to the toilet is turned ON. Also, check the water supply hose for kinks or tight loops and correct them. Make sure the sensor detects the user by adjusting your sitting position, as the sensor is designed to sense skin and may be affected by fabric. If problems persist, the filters might be blocked or damaged and need servicing.
Why is the seat not heated on my Kohler toilet?
If the seat is not heated on your Kohler toilet, it might be in Energy Save mode, in which case the seat will heat when used. If not, ensure that the heated seat feature is enabled. You may also need to adjust the heated seat temperature using the remote control.
What to do if the remote control of my Kohler toilet does not turn on?
If the remote control for your Kohler toilet does not turn on, first, reinstall the batteries, ensuring they are properly installed. If it still doesn't turn on, replace the batteries.
Why does my Kohler toilet flush unexpectedly?
If your Kohler toilet flushes unexpectedly, it is likely because the automatic flush feature is enabled. When automatic flush is enabled, the toilet will flush shortly after use.
Why does the spray wand move erratically on my Kohler toilet?
If the spray wand on your Kohler toilet moves erratically or fails to extend, it may be because the wash cycle was interrupted. Turn OFF the power button on the back of the toilet, wait 10 seconds, and then turn the power back ON. This may also resolve issues where the spray wand is not responding to the remote control. Ensure the sensor detects the user. Clean the wand with liquid soap for lubrication.
Critical safety warnings regarding electric shock, GFCI use, and UV radiation exposure.
Essential rules for safe operation, including supervision, proper use, and avoiding hazards.
Step-by-step instructions for correctly grounding the product to prevent shock.
Procedure for pairing the remote control with the toilet seat.
Solutions for power issues, startup sequence, and common flushing problems.
Troubleshooting steps for seat, wash, and spray wand functionalities.
Solutions for dryer, deodorizer, and remote control connectivity problems.
To Next Page
General