1349981-X2-A 4 Kohler Co.
Install the Mounting plate
2
3
4
5
1
Screw drive
1. Put the mounting plate(1) over the mounting hole on the bowl.
2. Put the adjusting plate(2) on the mounting plate.
3. Insert a bolt(3) through the mounting plate and the toilet mounting holes.
4. Thread a nut onto the bolt then tighter it by screw driver. Handtighten the
nut.
5. Check if the mounting plate is centered.
Note: Adjust the mounting plate (Stick the other anti-slide strip provided in
the accessory kit onto the one already stuck on as needed). It ts various
bidets, and the mounting plate easy to install.
To Next Page
Loading...
