Kohler K-10550 - Install the Robe Hook; Install the Glass Shelf

9. Install the Robe Hook
Start a setscrew into each post. Do not thread fully into the post.
If included, slide an escutcheon onto the wall plate.
NOTE: The escutcheon sits loosely until the post is in place and the
setscrew is tightened.
Align the robe hook assembly over the wall plate.
Tighten the setscrew with a hex wrench.
10. Install the Glass Shelf
Start a setscrew into each post.
If included, place an escutcheon on the wall plate.
Align a post over a wall plate. Repeat with the other post.
Loosely secure both posts with the setscrews.
Carefully place the shelf into position in the brackets.
Screw the cap down to hold the shelf in place.
Adjust the bracket assembly alignment as needed.
Tighten the setscrews on both the bracket assemblies and the
posts.
Anchors
Wall Plate
Screws
Large
Mounting
Hole
Escutcheon
Robe Hook
Setscrew
Robe
Hook
Cap
Glass Shelf
Glass Shelf
Plate
Setscrew
Anchors
Screws
1023327-2-B 8 Kohler Co.