1014299-2-B
Kohler Co.
4
Gasket
Brass
Tee
Rubber Washer
Flexible
Hose
Nut
Washer
Dished
Washer
Hose
Handle
Body Outlet
O-Ring
Copper Tube
2. Handle Body Installation continued
- Install the dished washer (dished washer may be removed for thick deck
applications) and nut to the bottom of the handle bodies.
- Align the bodies so the copper tubing faces to the outside.
- Wrench tighten the nuts.
- Remove any excess putty or sealant.
- Thread the hoses into the handle body outlets. Use a wrench to tighten,
but do not overtighten.
- Insert the gasket and rubber washer into the tee. Thread the tee onto the
spout shank.
- Hold the spout in position and tighten the tee securely. Do not
overtighten.
- Connect the flexible hoses to the tee inlets. Do not use thr ead sealant. To
avoid kinking the hoses, loop them as shown. Do not overtighten.
To Next Page
Loading...
