Kohler K-14406 - Spout Installation; Handle Body Installation

1014299-2-B
3
Kohler Co.
Nut
Apply
Plumbers
Putty
Metal
Washer
Escutcheon
Apply Plumbers
Putty
Handle
Body
Cross-
Handle
1. Spout Installation
- Apply a bead of plumbers putty or other sealant to the underside of the
spout according to the putty manufacturer’s instructions.
- Fit the spout through the top of the lavatory.
- Install the metal washer and nut. Position the washer so the second hole
lines up with the drain lift rod hole. Securely wrench tighten the nut.
- Remove any excess putty or sealant.
2. Handle Body Installation
- Apply a bead of plumbers putty or other sealant to the underside of the
escutcheons according to the putty manufactur er’s instructions.
- Insert the handle bodies into the mounting holes from the top of the
lavatory. Make sure the body marked “COLD” is installed in the
right-hand hole (as viewed from the front of the lavatory).