Tools and Materials
Before You Begin
WARNING: Risk of serious injury. When cutting the locker unit, take appropriate safety measures
including the use of breathing protection.
CAUTION: Risk of serious injury. Always wear safety glasses while cutting and drilling.
IMPORTANT! Dust will be generated when cutting the locker unit. Cutting the locker should be
performed outside or in a well ventilated area.
IMPORTANT! Leave this manual for the end user.
Read these instructions before installing or using this product:
•
The locker unit must only be trimmed in height. Do not cut down the sides.
•
The existing rough walls must be within 3/8″ (10 mm) of plumb.
•
The locker unit must be braced using 2x4’s around the entire unit.
•
Use color matched silicone sealant around the locker unit.
•
Cover the shower base with a drop cloth or other protective material to avoid damage.
•
Follow the construction adhesive and silicone sealant instructions for application and curing time.
•
Inspect product for damage after unpacking, prior to installation.
•
A router may be used to cut the locker unit. The router bit will dull quickly.
Denatured Alcohol Rags Shop Vacuum
Breathing
Protection
Plus:
• Standard Woodworking Tools
• Spring Loaded Braces or Lumber
(to create bracing)
• Sawhorses
• Drop Cloth
Sanding Block
1-2 Tubes Color Matched
100% Silicone Sealant
Caulk Gun 7-1/4" Circular Saw
and Fine Toothed Blade
4+ tubes Non-Solvent
Based Construction Adhesive
DENATURED
ALCOHOL
1248926-2-A 2 Kohler Co.
To Next Page
Loading...
Need help?
General
