Why is my Kohler Bathroom Fixture handle leaking?
If the handle of your Kohler Bathroom Fixture is leaking, the handle seal or handle assembly may be damaged. Replace the B-73-A handle or repair it using the B-51-A handle repair kit.
Why is my Kohler Bathroom Fixture not flushing?
If your Kohler Bathroom Fixture flushometer isn't flushing, first ensure that the control stop or main supply valve is open. If the issue persists, the handle assembly might be damaged; consider replacing the B-73-A handle or repairing it with a B-51-A handle repair kit. A damaged relief valve could also be the cause, so consider replacing it as well.
What to do if Kohler Bathroom Fixture flush is too long?
If your Kohler Bathroom Fixture has a long flush or fails to shut off, start by checking the diaphragm assembly for a dirty by-pass hole (upper filter ring). Remove the diaphragm assembly, disassemble the filter rings, wash them under running water, and reassemble. Replace if necessary. Also, a damaged relief valve or diaphragm assembly can cause this issue, so consider replacing them. Ensure the correct diaphragm assembly is installed for your fixture type. A damaged inside cover or a drop in line water pressure could also be the cause. In the latter case, close the control stop until pressure is restored. Lastly, check if the relief valve is seated properly; if not, disassemble the diaphragm components, wash them, and reassemble.
What causes a short flush in my Kohler Bathroom Fixture?
If your Kohler Bathroom Fixture valve closes immediately, it could be due to a worn or damaged diaphragm assembly, which should be replaced. Another potential cause is a damaged handle assembly; consider replacing the B-73-A handle or repairing it with the B-51-A handle repair kit. Also, check that the correct diaphragm assembly is installed for your fixture type and replace the relief valve or diaphragm assembly if needed.
How to stop water splashing from my Kohler Bathroom Fixture?
If water splashes from your Kohler Bathroom Fixture, the control stop may be open too wide; adjust it to achieve the desired water volume. Also, ensure the correct diaphragm assembly is installed for your fixture type; replace it or the relief valve to match the fixture's flush volume requirements.
What to do if my Kohler Bathroom Fixture makes a chattering noise when flushing?
If you hear a chattering noise during the flush of your Kohler Bathroom Fixture, the inside cover might be damaged; install a new A-71 part. Alternatively, the relief valve or diaphragm assembly could be damaged; consider replacing them.
Why is there insufficient water to siphon my Kohler Bathroom Fixture?
If your Kohler Bathroom Fixture isn't siphoning adequately, first, check that the control stop is open wide enough. If not, adjust it for the desired water volume. A damaged diaphragm assembly could also be the cause, so consider replacing it. Ensure you have the correct diaphragm assembly installed for your fixture type. Insufficient water volume or pressure from the supply can also cause this. Increase the flow rate or pressure to the valve. If gauges aren't available, remove the relief valve and open the control stop. If the fixture siphons, you need more water volume; install a higher flushing volume relief valve or diaphragm assembly or cut the flow ring from the guide. If it doesn't siphon, increase water pressure and/or volume at the supply and contact the fixture manufacturer for m...
Key physical and functional characteristics of the toilet bowl.
Regulatory and industry standards the toilet bowl complies with.
Designations for the particular toilet bowl models available.
Suggested additional items to purchase for the toilet bowl.
Technical details and dimensions of the toilet bowl.
Terms and conditions of the manufacturer's one-year warranty for plumbing products.
Comprehensive list of replacement parts for the Royal flushometer.
Guidance for diagnosing and resolving operational problems with flushometers.
Procedures for cleaning and maintaining the flushometer's finish and function.
Pre-installation checks and necessary preparations for the flush valve.
Step-by-step process for physically installing the commercial toilet flush valve.
Details of the manufacturer's one-year warranty for Kohler plumbing products.
Technical drawing showing required plumbing and mounting dimensions for urinal installation.
Sequential instructions for installing the Kohler urinal.
List of available replacement parts for the urinal.
Manufacturer's warranty terms applicable to the urinal.
Description of exposed and concealed sensor-activated flushometer models.
Diagrams detailing rough-in dimensions for urinal flushometer installations.
Key considerations and warnings for proper flushometer installation.
Diagrams detailing rough-in dimensions for water closet flushometer installations.
Guidance for diagnosing and resolving operational problems with Optima flushometers.
Catalog of replacement parts for Chicago Faucets products.
Terms of the manufacturer's limited warranty for commercial faucet products.
General| Brand | Kohler |
|---|---|
| Model | KINGSTON K-4325 |
| Category | Bathroom Fixtures |
| Language | English |
To Next Page
